THE CURIOSITY WORKSHOP / 001

The world is full of how.

A closer look at the clever things hiding in plain sight. Explore the mechanisms, then watch the stories behind them.

For the curious, the tinkerers,
and the “but how?” people.

LOOK CLOSERASK WHYSEE HOW IT WORKSSTAY CURIOUS

HANDS-ON, MINDS-ON

A little motion.
A lot of insight.

Make a prediction, try the mechanism, then discover why it works. Three small experiments for a curious mind.

MECHANISM NO. 01CHANGE THE RATIO
01 / GEARS

One turn starts another.

When two gears mesh, they turn in opposite directions. A gear with fewer teeth turns faster than its partner.

For each turn of the large gear, the small gear turns 1.67 times.

Explore gears
PAUSE & PREDICTWhat happens next?

Keep the driving gear at 20 teeth and turning at the same speed. Replace its 12-tooth partner with a 20-tooth gear.

What happens to the second gear?

It slows down and still turns the opposite way. With 12 teeth it makes about 1.67 turns per turn of the driver. With 20 teeth it makes one turn. Two externally meshing gears turn in opposite directions.

MECHANISM NO. 02PRESSURE · FORCE
02 / HYDRAULICS

A little force lifts a lot.

Fluid carries pressure between the pistons. The larger piston moves a shorter distance while producing a larger force.

Explore hydraulics
PAUSE & PREDICTWhat happens next?

Imagine sealed pistons connected by liquid, with no leaks or trapped air. Push the small piston down.

How does the larger piston move?

It moves up through a shorter distance. The same volume of liquid leaves the small cylinder and enters the large one. A larger piston area needs less travel for that volume. Ideally, the larger output force is exchanged for a shorter movement; no extra energy is created.

MECHANISM NO. 03ROTATION · LIFT
03 / CAMS

Round and round becomes up and down.

The cam rotates around an offset shaft. Its edge lifts the follower and lets it fall once per turn.

Discover more
PAUSE & PREDICTWhat happens next?

Follow the roller on this single offset circular cam. Assume it stays in contact with the cam as the shaft turns.

In one full turn, how many times does the follower rise and fall?

Once. The offset brings the cam’s highest and lowest positions past the follower once per revolution. The follower moves up and down while the shaft turns. Other cam shapes can produce different motion patterns.

Illustrations are simplified to show the idea. Motion can be paused at any time. Try the interactive 3D gear model ↗